Leave Your Message
Products Categories
Featured Products

TJSH-500 Gantry frame high speed precision press

There are many feeding methods for punch machines. Most of the materials used in stamping production are sheets, cut materials, strips and blocks of various specifications.

    Main technical parameters:

    Model

    TJSH-500

    Capacity

    500 Ton

    Stroke of Slide

    60 mm

    50 mm

    40 mm

    30 mm

    20 mm

    70-150

    80-200

    100-300

    100-300

    100-300

    Die-Height

    500 - 550

    Bolster

    2900(3600)X 1300 X 320 mm

    冲Area of Slide

    2800(3500)X 1100 mm

    Slide Adjustment

    50 mm

    Bed Opening

    2600(3300)X 480 mm

    Motor

    100 HP

    Gross Weight

    90000 Kg

    Adjust Die-Height

    Electric motor depth adjustment

    Plunger No.

    Two Plunger(Two Points)

    Electrical- System

    auto error-det

    Clutch&Brake

    Combination & Compact

    Vibration System

     Dynamic Balancer & Air Mamts 

    Dimention:

    TJSH-500elj

    Feeding method of punch press

    There are many feeding methods for punch machines. Most of the materials used in stamping production are sheets, cut materials, strips and blocks of various specifications.

    Sheet metal is a widely used material in punch stamping production and is suitable for mass production. The specifications are in accordance with the national standards. The use of standard sheet materials may increase the tail material and reduce the material utilization rate. However, if effective nesting and layout are adopted, this shortcoming can be made up for. In many productions, you can also use the best layout plan to clarify the specifications according to the process regulations, and order them professionally from the steel mill. This can increase the utilization rate of materials, but the price will be slightly higher than the standard specification. During production, the sheets must also be cut into various strips or blocks according to process specifications and then stamped.

    Cutting materials (pipe materials) are used in many productions of high-precision punch machines. The width of the cut material is generally less than 200mm. Depending on the material, there are different width specifications, ranging from several meters to tens of meters in length, and some thin materials are hundreds of meters long. The high-speed punch machine uses only pipe materials for stamping. The high-speed punch machine is equipped with an automatic feeder and does not require manual feeding.

    The block material is suitable for the stamping of small batches of parts and expensive non-ferrous metals.

    The strips are cut from sheet metal according to the needs of stamping parts. Used for stamping of small and medium-sized parts.

    The feeding methods of the punch machine include manual feeding, automatic feeding and semi-automatic feeding. The appropriate feeding method should be selected from the comprehensive consideration of production efficiency, production cost, convenient operation and safety.

    Generally, manual feeding has high labor intensity and low production efficiency, but it is low-cost. Low-speed punch machines are suitable for small batch production. Automatic or semi-automatic feeding is mostly used for large, medium and large batch production of high-precision punch machines and multi-process continuous mold production. When automatic or semi-automatic feeding equipment (machine equipment) is available, even for small batch production, choosing automatic or semi-automatic feeding can not only improve production efficiency, reduce labor intensity, but also contribute to safe production.

    description2