Leave Your Message
Products Categories
Featured Products

TJSH-220 Gantry frame high speed precision press

Before installing the precision punch machine, you must first make sure that the cutting edge of the mold is sharp, there is no chipping on the cutting edge of the concave mold, and there are no missing corners on the punch. If there is a chip or missing corner, the wound must be repaired first.

    Main technical parameters:

    Model

    TJSH-220

    Capacity

    220 Ton

    Stroke of Slide

    50 mm

    40 mm

    30 mm

    20 mm

    150-200

    100-300

    100-350

    100-350

    Die-Height

    490

    495

    500

    505

    Bolster

    1900 X 1100 X 230 mm

    Area of Slide

    1900 X 800 mm

    Slide Adjustment

    60 mm

    Bed Opening

    1700 X 250 mm

    Motor

    60 HP

    Gross Weight

    37000 Kg

    Adjust Die-Height

    Air motor depth adjustment

    Plunger No.

    Two Plunger(Two Points)

    Electrical- System

    auto error-det

    Clutch&Brake

    Combination & Compact

    Vibration System

     Dynamic Balancer & Air Mamts 

    Dimention:

    TJSH-220yn5

    FAQ

    What should you pay attention to when installing a precision punch machine?

    The development trend of precision punch technology comprehensively integrates the manufacturing cycle, greatly saves manpower and improves production efficiency. Nowadays, productivity requirements are getting higher and higher, which is also an important change in China's modern high-speed precision stamping production. With the development of precision punch technology, it has been favored by more and more companies. Today, the editor will explain to you what matters should be paid attention to when installing a precision punch press?

    1. Before installing the precision punch machine, you must first make sure that the cutting edge of the mold is sharp, there is no chipping on the cutting edge of the concave mold, and there are no missing corners on the punch. If there is a chip or missing corner, the wound must be repaired first.

    2. Before clamping the mold, a silicon steel sheet should be inserted between the upper and upper molds to prevent injuries caused by transportation.

    3. Before installing the mold on the precision punch, use a whetstone to grind off the burrs on the bottom and top sides and remove the dirt. If there are burrs or garbage on the left and right planes of the mold, it will cause the punching burr deviation.

    4. Adjust the slider stroke of the precision punch to a satisfactory position and press the upper mold. Make sure that the mold handle or the upper surface of the mold base is aligned with the bottom edge of the slider, and lightly tighten the screws of the lower mold plate. Then adjust the slider of the punch upward and remove the silicon steel sheet in the center. Loosen the screws of the lower molding plate, adjust the slider downward until the punch enters the concave mold 3~4mm, and tighten the screws of the lower molding plate. After punching a new mold on a precision punch machine, the punch must enter 3~4mm into the die, otherwise the punch will chip or the die will swell and crack.

    5. Lift the slide block to the top dead center position, adjust the punch rod stop screw until it is tight and secure, and then idle it a few times to observe whether the mold and punch mechanisms are working normally. If there are no abnormalities, stamping production can be carried out.

    description2

    Leave Your Message

    AI Helps Write